openclaw-android
Run OpenClaw on Android with a single command — no proot, no Linux
- 1.8k
- Kotlin
- MIT
- 5 wk ago
Run OpenClaw on Android with a single command — no proot, no Linux
An extremely compact offline media server for Movies, Shows, Books, and Music.
Datasheet-derived comparison of all 14 ESP32 SoC variants (ESP32 → S31): specs, deep sleep, security/PQC readiness, and reasoned multi-chip combinations. Community-maintained, not affiliated with Espressif.
Simplest DIY low power, low cost, standalone or web connected IOT sensors network framework using ESP32 or ESP8266 (no third party service required).
Low-power, offline retrieval (RAG) for disaster and infrastructure-failure guidance.
Low Power Optimization of the SAM D21 MCU using the Arduino Framework
A low power RF data link between two ATmega328's based Arduino units , Sensor data is transferred Via a 433 Mhz transmitter. and then displayed on an OLED CH1115.
Low-power ESPHome firmware for the Seeed XIAO ESP32-C6 soil moisture sensor. ~600 days on one AA cell, measured.
Real-time ear biometric recognition on STM32F407 with FreeRTOS - 95%+ accuracy, 120ms latency using PCA/LDA/DCVA on ARM Cortex-M4
Arduino Core for SAM D21 extensions to support fine grained power management, especially for the modules ADC, EIC, RTC and TC. Also supports reading Vcc, Vcore and internal temperature.
Dalian/Waveshare Good Display E Ink Display Driver for Arduino
Adruino driver for Texas Instruments HDC10XX humidity and temperature sensors with I2C bus.